User's Manual

The menus of the control panel of Printer are as below table.
Menu Submenu Description
>System Config.
>>Combination
To set module combination. Refer to
the chapter
2.1.10 for modules combination setting.
>>Operation Mode To set Printer as a Master device. Default is Master.
>>Insert Dir To set the direction of Card In. Default is the left.
>>Eject Dir To set the direction of Card Out. Default is the right.
>>Auto Card In
To set the automatic card feeding when the card is
detected at the direction of Card In. Default is OFF.
>>UserCounterClear To reset user issue count.
>Network Config.
>>DHCP To set whether to use DHCP function. Default is On.
>>IP Address IP address to be used when DHCP is OFF.
>>Network Mask Network Mask to be used when DHCP is OFF.
>>Gateway Gateway address to be used when DHCP is OFF.
>Print Config.
>>XStartPosition
To set the start position of the printing on the card’s
X-axis (shorter side).
>>YStartPosition
To set the start position of the printing on the card’s
Y-axis (longer side).
>>YEndPosition
To set the
end position of the printing on the card’s
Y-axis.
>>YScale
To set the length of printed image on the card’s Y-
axis.
>>TotalDensity To set the total printing density.
>>ColorDensity To set the color density
>>BlackDensity To set the resin black density.
>>OverlayDensity To set overlay density.
18