User's Manual

Figure 90 Basic Setup of CardPrinter70Setup

① To show connected Printer.

Device:

The Printer that the adjustment is needed can be selected by using the pull-down

menu.

“IDP SMART-70 Card Printer” is the connected Printer’s name. “SMART” is the

connected Printer’s ID, “USB006”

is the connected port.

Allow Network Printer:

If the Allow Network Card Printer is selected, Printers connected via

network also appear in the “Device” list.

② To set administrator password and user password.

Change Root PW:

To set administrator (root) password. This password is used to verify user

authority for CardPrinter70Setup and is also required as administrator password when the

User Authentication option on Security is set on advanced setup.

(When Printer is installed at the place where security is required, please set password at the

same time with the installation of Printer.)

Change User PW:

To set user password for user authentication. This password is required

as user password when the User Authentication option on Security is set on advanced

setup.

③ The firmware version, serial number of Printer, serial number of TPH, resistance value of

TPH, type of TPH is shown.

④ The printing area on card is shown. It shows

exaggeratingly for user convenience and is not

real position.

⑤ To set the printing area on card. Please set it properly to print on an entire card because

SMART-70 is a direct thermal card printer. When you click “⑦ Print”, a card is printed as

like “④ example”. Please set values properly that all circles of each corner are printed and

①

②

③

④

⑤

⑥

⑦

⑧

⑨