User's Manual

blank spaces are narrower than 0.5mm on the top and the bottom of a card. Please set
values by following order.
X Start Position:
Please set the right and the left of printing position on card properly by
adjusting X position.
Y Start Position:
Please set the start position of printed example image and blank space in
the top is 0.4mm ~ 0.5mm.
Y End Position:
Please set the end position of printed example image and blank space in
the bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger value for
“Y scale” than
default.
Y Scale:
Please set to print all circles in the bottom of card.
⑥ To set printed density. SMART-70 enables to set different density for each color, resin
black and overlay. So, proper setting on each density is needed for high quality. Please
optimize the quality by adjusting each value. To optimize, you repeatedly adjust the density
and print a Calibration card by using color ribbon and clicking “⑦ Print”, and please check
the printed state until you get the optimum.
Total Density:
To set all of the density (Color, Black and Overlay) at one time.
YMC Density:
To set color density. Please maximize YMC density as you can, which enables
to extend range of color and to print vivid images. If it is too strong, green or red marks are
appeared as Figure 91. If it is too weak, the print quality will be dull.
Figure 91 Color density
Black Density:
To Set resin black density. In the picture, barcode is printed by resin black.
When density is too strong, barcode is printed too thick. When density is too weak, barcode is
too thin. Please adjust resin black density to print clear barcode. Please refer following
pictures.
62