User's Manual

 Uneven or bad surface of card.
Please change cards.
 Card feeding or printing roller is contaminated.
Please clean the rollers by using cleaning kit.
 Outdated printer.
Please contact the local supplier.
5.1.5 Unplanned color print
 Non-standard or bad cards.
Please change cards
(ISO CR80 card (54mm x 86mm) must be used).
 Card feeding or printing roller is contaminated.
Please clean the rollers by using cleaning kit.
 Malfunctioned ribbon sensors.
Please contact the local supplier to replace the sensors.
 Outdated printer.
Please contact the local supplier.
5.2 Card supply
5.2.1 Card is not supplied or 2 cards are supplied from Input Hopper
 Non-standard or bad cards.
Please change cards
(ISO CR80 card (54mm x 86mm) must be used).
 Card cartridge is improperly loaded.
Please properly load the card cartridge into
Input Hopper again.
 Card thickness of card cartridge is improperly set.
Please properly adjust the card thickness control lever
depending on the thickness of card. In case card is not
supplied, please adjust the lever to the right.
In case 2 cards are supplied, please adjust the lever
to the left.
5.3 Card jam
5.3.1 Card jam in Input Hopper
Figure 104 Printing quality trouble 4
Figure 105 Printing quality trouble 5
Figure 106 Card supply problem 1
76