User's Manual

2.1.10 Module combination setting

Since SMART-70 is operated by the combination of multiple modules, the configuration for

multiple modules combination must be set during the first installation of the modules. Printer

module acts as master who is responsible to communicate with PC and control other modules,

and if Printer module is not connected, Laminator module will act as master. The configuration for

multiple modules combination can be set in the control panel of Printer module as below. SMART-

70 Printer searches connected modules in booting, if the combination of connected modules is

different with the configuration for multiple modules combination, Indicator LED is turned to

yellow and the message for checking modules combination is displayed. Please follow below steps

to set the configuration for multiple modules combinations for initial setting.

A. The modules combination is IPFLO (Input Hopper + Printer + Flipper + Laminator + Output

Hopper) but the configuration is different with the actually connected modules, so the

configuration for multiple modules combination must be set again.

Please press the [Select] button indicated by red arrow.

Figure 43 Modules combination checking

B. Existing modules combination is shown. Please press the [Select] button indicated by red arrow

to adjust the configuration for multiple modules combination.

Figure 44 Existing modules combination