User's Manual

55
Figure 78 Input / Output settings
3.1.4 Input / Output settings
Supply Tray
Supply: If there is one Input Hopper, please
select “Auto”. If there are multiple Input
Hoppers, please select the Hopper which
will be used.
Tray: Please select “CR80” because SMART-70
only supports CR80 cards.
Output Tray
Output: If there is one Output Hopper select
“Auto”. If there are multiple Output
Hoppers, please select the Hopper which
will be used.
Figure 79 Printing settings
3.1.5 Printing settings
Do Printing: To set whether print or not.
Print Side: To set the single sided or dual sided
printing when Flipper is installed.
Front / Back
Color: To set the color or mono printing.
Flip: To turn the printed image on card.
Mask: To set the printing area on card. The
predefined masks (normal card, smartcard,
magnetic stripe card, etc.) or user defined
mask cab be used.
Printing
Ribbon: The print ribbon type is used for
printing and can be automatically
recognized.
Speed: To set the printing speed.
Mode: To set the all or partial printing.
Dither: Set the dithering types.
Sharpening: To calibrate the printed image
sharpness.
Ribbon Save: To set that the card is printed
by using the split function when the mono
ribbon is used.
User defined mask uses BITMAP file (1012 x
636 pixels).
Blue(RGB(0,0,255)) : Print and Overlay
Light blue(RGB(0,255,255)) : Overlay only
Pink(RGB(255,0,255)) : Print only
Yellow(RGB(255,255,0)) : Florescent only