User's Manual

HM-E200 User Manual
6
 Charging the Battery Pack
 The battery pack can be charged at ambient temperatures between 0 and 40°C.
 The time required to charge the battery pack varies depending on the voltage and the ambient
temperature.
Normally, it takes 3 to 4 hours to charge the battery pack.
 It will take longer to charge the battery pack if you print while charging the battery pack.
 Do not remove the battery pack while it is being charged.
 Fully charge the battery prior to using the printer. Otherwise, the performance of the battery may
be affected.
 There is no need to completely discharge or use up a rechargeable Lithium-ion battery before
recharge it.
 It is normal for the battery pack to be hot after it has finished charging or been used.
 Notes about Using the Battery Pack
 Only use a designated battery pack.
 Only use the designated battery charging method.
You cannot use a USB cable other than the designated USB cable.
 Do not throw the battery into a fire, place it near a flame or heating device, or leave it in a hot
environment (under direct sunlight, in a car, etc.).
 Do not use a battery pack that has been dropped or subjected to a shock in some other way.
 Do not disassemble or modify the battery pack.
 Do not short the terminals of the battery pack or get it wet.
 Do not place the battery pack in a bag with a small metal object (such as a key).
 If any battery fluid gets on your skin or clothing, immediately wash the affected area with fresh
water. Otherwise, skin damage may result.
 Notes about Storing the Battery Pack
 If you do not intend to use the battery pack for a long time, be sure to remove it from the printer.
 Keep the battery out of the reach of children. In addition, be careful that children do not remove the
battery.
 Store the battery pack in a cool place.
* We recommend that you store the battery pack in a dry area with an ambient temperature of 15
to 25 ℃.
* Avoid storing the battery in locations with high or extremely low temperatures.