User's Manual

HM-E200 User Manual
17
2.5 Belt Clip
2.5.1 Install the Belt Clip
Follow the procedure below to attach the belt clip to the printer.
1. Make sure that you are attaching the belt clip in the right orientation, then screw the screw that
comes with the belt clip into the designated screw hole to attach the belt clip to the printer.
2. Use a screw driver to firmly screw in the screw.
2.5.2 Using the Belt Clip
When the printer is attached to your belt, you can use it like the picture below.
Note: Be careful not to drop when use a belt clip.Velcro be securely fixed.
Hold the printer firmly with your hand when you swipe a magnetic stripe card or cut paper. If it is not
held firmly, you may fail to read card data or cannot cut paper smoothly with the tear bar.