Manualshelf

User's Manual

ManualsBrandsIDRO ManualsElectronicsUHF Fixed Type 4 Port RFID Reader
11121314151617181920
IDRO900F User's Manual
13
IDentification with Radio and Optical
4. 1 Mechanical Installation
4. 1. 1 Mounting the RFID Reader
IDRO900F Reader has a mounting hole that allows 4 #10(M5) screws to be used.
Drill the mounting surface in advance according to the dimension of [Figure 4.1.1]. The Mounting surface shall
be capable of supporting up to 1.88lb (580g).
[Figure 4.1.1 ] IDRO900F Mount Hole Dimensions(dimensions in mm)
4. 1. 2 Mounting the Antennas
IDRO900F RFID Reader supports up to four Antennas.
In most applications, such as conveyor systems or access control, one or two antennas are commonly used,
while four configurations are used for entrance to doors and loading dock doorways.
As shown in [Figure 4.1.2] below, it is recommended to use antenna brackets that can adjust the antenna
direction upper, lower, left and right.
The Antenna bracket should be installed on a rigid surface or frame to ensure that it does not damage or
break later. For best performance, we strongly recommend adjusting the antenna mounting position and
direction.