IDRO UHF Fixed Type 4 Port RFID Reader : User's Manual : Page 25

IDRO900F User's Manual

25

IDentification with Radio and Optical

LAMP OFF(Initial state) → Tag reading → LAMP ON

②. Click Properties on the Reader@Express → Click GPIO and set the Output like below → Apply →

Close

> If OUTPUT LEVEL and OUTPUT FLASH are set as shown above, when LAMP is connected to GPIO

output 1 port, it operates as follows.

LAMP ON(Initial state) → Tag reading → LAMP OFF

③. OUTPUT PATTERN : Used when Host PC gives random signals to the GPIO Output port.

Generally intended to control the GPIO output in HOST, used to test whether the reader is

functioning normally.

(1) GPIO Intput

Used as a sensor input, and it is used for the application system in which the reader operates when a sensor

is detected.

• Connection Diagram

Use Power from external device (sensor) for power(V+,V-)..