User's Manual

DISMANTLING AN HYDRA SYSTEM
IDS GeoRadar S.r.l. MNG/2017/009 Rev 1.1 42/ 54
7 DISMANTLING AN HYDRA SYSTEM
When dismantling the measurement site, carefully verify exactly what is to
be removed and accurately place the pieces to be stored in the packing
cases.
Send the PTU to the “home” position (Pan=0°, Tilt=0°) before the
dismantling of the system, in order to fit it in the transport case.
7.1 Dismantling the measurement site
The following procedure should be followed in order to remove the HYDRA
Radar Sensor from the measurement site:
1. Switch off the tablet;
2. Turn OFF the PSU and close the lid;
3. Disconnect the AC Power cable and the Power Cable Adapter from
the main power line;
4. Disconnect the AC Power Cable, the Camera Ethernet Cable, the PTU
Main Cable and the Wi-Fi antenna from the PSU, cover each
connector with the relative cap;
5. Disconnect the Camera Ethernet Cable from the Camera;
6. Disconnect the PTU Main Cable from the Pan-Tilt, cover the
connector with the cap;
7. Remove the Camera from the PTU;
8. Disconnect the PTU Data Cable, the Triggering Sensor Cable, and the
Laser Cable, from the back of the Radar Sensor, cover each connector
with the relative cap;
9. Remove the Radar Sensor from the PTU, unlocking the two metallic
levers and unscrewing the fixing knob;
10. Unscrew the Positioning Unit from the Tripod using the hex key;
11. Remove the Positioning Unit from the Tripod by lifting it up;
12. Close the cases after verifying that all parts have been packed;