User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N°doc: MN/2009/070 - Rev. 1.1

IBIS-L v.02.00 - User manual

49 / 65

16. inject enough resin into each hole to block the studs (Fig. 4.10 );

17. insert the studs, still attached to the template, into the holes making sure that the position

coincides with that previously measured;

18. wait for the resin to dry completely (for the time required, read the instructions on the

tube), then remove the 5 nuts and the M16 washers that keep the studs fixed to the

template and lift off the template (the base should now be left with the five studs with 5

nuts and 5 M16 washers).

4.1.3 Mounting the linear scanner

The following sequence of operations describes the installation of the linear scanner onto

the anchoring elements:

1. mount the two base washers on the two closely positioned studs (Fig. 4.11);

Fig. 4.11 – Mounting the base washers

2. fix the positioning fork on the other stud on the opposite side of the base, positioning it

with the axis of the two screws perpendicular to the direction of the axis of the template;

3. screw the third base washer above the positioning fork (Fig. 4.12);

NOTE

: the resin is malleable for about 5 minutes before setting at summer temperatures, so the

time between the moment of the first injection to the insertion of the studs into the resin

filled holes must be less than this to avoid the need to drill new holes.