User's Manual

IDS Ingegneria Dei Sistemi S.p.A. N°doc: MN/2009/070 - Rev. 1.1

IBIS-L v.02.00 - User manual

57 / 65

5. FIRST START UP

Once the instrument has been installed according to instructions, it is ready for use. The

following list describes the operations requires to start up and use IBIS-L:

1. if necessary, connect the power supply module to an external power supply

using the cable supplied in the upper area of the power supply module and

switch on the switch that controls input from mains (external AC input). This

mode avoids using the charged batteries.

2. start up the control ad acquisition PC;

3. switch on the three switches on the power supply module that control :

a. the sensor (sensor power supply);

b. linear scanner (linear scanner power supply );

c. pc power supply (Lap Top PC );

4. connect the USB connector in the upper area of the power supply module to

the PC (it is always best to connect it after having switched on all the

equipment to avoid any possible recognition problems of the USB device by

the operative system);

5. start the IBIS-L Controller v. 02.00.002 program clicking on the desktop icon;

Fig. 5.1 - Opening window of the control and acquisition software