User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/030 - Rev. 1.2

Safe Rail System Data Acquisition Software

Fig. 4-9 –Calibration file selection window

Pressing the

New

button from the window of Fig. 4-9 opens the window

shown in Fig. 4-10 from where you can edit the calibration filename. Now

press the

button to open the window shown in Fig. 4-11, from where you

can set the gain values to apply on the radar map.

Fig. 4-10 – Gain window

The following parameters can be set in the window shown in Fig. 4-11

•

the time in nsec in the

Time

column,

•

the value of gain to apply on the radar map based on the values set in the

Gain

column.

Then pressing the

Apply

button, you can draw the gain curve based on these

values.

As an alternative to the above procedure, you can use the graphics mode,

which consists of manually inserting the individual points of the gain curve.

To activate this procedure:

point with the mouse on the red square on the right edge of the

window, corresponding to the value 0dB (Fig. 4-12 and Fig. 4-13)