User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/030 - Rev. 1.2

Safe Rail System Data Acquisition Software

Fig. 4-32 – Data saving window

When you want to save the acquired data on the disk, you can choose to

press the button shown in the window in Fig. 4-31, then

create the temporary file by pressing the

YES

button in the window in Fig.

4-32.

But you can also choose to temporarily save the data acquired up to that

point by pressing the button shown in Fig. 4-31, and

continue to push the trolley in the same direction to the end of the scan,

then definitively save it using the above procedure. This save scan

procedure is particularly recommended for longer scans that may reach up

to a few hundred meters in length.

By pressing the button, you cancel the last radar scan

performed. Once the radar map has been completely deleted, the

coordinates are updated to those of the preceding scan.

Pressing the button terminates the acquisition phase,

then the software will save definitely all data storage of the same mission

by pressing the OK button in the window appearing (see upper

Fig. 4-33

);

then you move on to the window shown in Fig. 4-33 which has all the

review functions activated.