User's Manual

IDS Ingegneria Dei Sistemi S.p.A. Protocol: MN/2009/030 - Rev. 1.2

Safe Rail System Data Acquisition Software

The name of the selected acquisition can be changed using the

button in the window shown in Fig. 4-33.

Write the new name of the selected acquisition in the window shown in

the window in Fig. 4-37; once the new name has been set, press the

button to confirm.

Fig. 4-37 – Rename Acquisition Window

Any previously saved acquisition can be deleted by pressing the

button in the window shown in Fig. 4-33 using

the window shown in Fig. 4-38; the delete operation has to be

confirmed by pressing the

YES

button in this window.

Fig. 4-38 – Delete acquisition window

Pressing the

button from the window shown in

Fig. 4-33 reloads the last acquisition, enabling you to continue

performing other scans in the same acquisition area, following the

procedure described in Par.4.6.

Pressing the button shown in Fig. 4-7 closes

down the software. Before closing it down, the system reminds you to

disconnect the Radar Control Unit with the message window shown in

Fig. 4-18.