User Manual

18/ 22
Fig. 1.6 – Fixing the white frame
When the rack is in place the white frame can be connected to it. Just put the central part
of the frame in the pivots of the rack and place the locking bars over the joints (Fig. 1.6).
Fig. 1.7 – Link to the antenna sledge
Use the four strips with karabiner to link the white frame with the metallic plates of the
antenna sledge (Fig. 1.7). Link the cross arms with their corresponding joints: to do this
operation easily, you may lift a little bit the sledge from the ground using the motor rack.
1.1.1 Cabling
In the following chapter you will find the description of the Stream X cabling. Your
system will be supplied with:
One 5m antenna cable: this one will connect ANT1 port of the DAD unit to IN
connector of the rightmost antenna frame (looking from behind).
Pivot
Locking
bar
Joint
Strip with
Karabiner
Metallic plate
Arms
joints