User Manual

19/ 22
One 1.5m antenna cable: this one will connect the two modules of the array in
cascade (not required for the STREAMX600 system)
Three Doppler encoder cables: these unique shaped cables will link the encoder
with its piloting black box and the black box with both the wheel port of the DAD
and the radar battery (small one).
LAN cable: this cable connects the DAD to the laptop.
Crocodile cable: this cable is used to power the motor rack
1.2 The DAD Fast Wave Control Units
The DAD Control Unit is the control unit responsible for directing the antennas
and digitalising the acquired radar data.
The DAD Control Unit has the following ports
Lan Port for a network connection to the Notebook Computer
Battery Port to connect the battery
Wheel Port to connect the position sensor wheel
Ant.1/CHAINE - Ant.2 for radar antenna connection
Power switch with pilot light
Wireless antenna connector
-
Fig. 1.8 – DAD side Fast Wave with Battery Port, Lan Port and wireless
connector
LAN port
Battery Port
Start up
button
Wireless
antenna
connector
Wireless
plug