User's Manual

Target heart rate
zone
Zone 1 to 5
Lower heart rate
limit range
30 to 220 bpm
Upper heart rate
limit range
80 to 240 bpm
Distance
measurement
range
0 to 9999.99 unit (unit is
km or mile)
Step
measurement
range
0 to 99999
Maximum lap
count
99
Cadence
measurement
range
1 to 199 rpm
Number of
interval training
2 to 5
Calorie range 0 to 9999 kcal
Fat burn
percentage range
0 to 100%
Fitness Index
range
1 to 66
POWER
Watch 1 x CR2032 3V lithium
battery
SZ909 chest belt 1 x CR2032 3V lithium
battery
OPERATING ENVIRONMENT
Operating
temperature
For watch
C to 40°C
(3F to 104°F)
For SZ909 chest belt
C to 40°C
(41°F to 104°F)
Storage
temperature
For watch and SZ909
chest belt
-20°C to 60°C
(-4°F to 140°F)
PRECAUTIONS
To ensure you use your product correctly and
safely, read these warnings and the entire user
manual before using the product:
Use a soft, slightly moistened cloth. Do not
use abrasive or corrosive
cleaning agents,
as these may cause damage. Use
lukewarm water and mild soap to clean the
watch thoroughly after each training session.
Never use the product in hot water or store
it when wet.
Do not subject
the product to excessive
force, shock, dust, temperature changes, or
humidity. Never expose the product to direct
sunlight for extended periods. Such
treatment may result in malfunction.
Do not
bend or stretch the transmitter part
of the chest belt.
Do not tamper with the internal components.
Doing so will terminate the product warranty
and may cause damage. The main unit
contains no user-serviceable parts.
Do
not scratch hard objects against the LCD
display as this may cause damage.
Take precautions when handling all battery
types.
Remove the batteries whenever you are
planning to store the product for a lon
g
period of time.
When replacing batteries, use new batteries
as specified in this user manual.
The product is a precision instrument. Never
attempt to take this device apart. Contact
the retailer or our customer
service
department if the product requires servicing.
Do not touch the exposed electronic
circuitry, as there is a danger of electric
shock.
Check all major functions if the device has
not been used for a
long time. Maintain
regular internal testing and cleaning of your
device. Have your watch serviced by an
approved service center annually.
When disposing of this product, ensure it is
collected separately for special treatment
and
not as normal household waste.
Due to printing limitations, the displays
shown in this manual may differ from the
actual display.
The contents of this manual may not be
reproduced without the permission o
f the
manufacturer.
NOTE The technical specifications for this
product and the contents of the user manual
are subject to change without notice.
NOTE Features and accessories will not be
available in all countries. For more information,
please contact your local retailer.
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to
learn more about Oregon Scientific products.
If you're in the US and would like to contact our
Customer Care department directly, please visit:
www2.oregonscientific.com/service/support.asp
For international inquiries, please visit:
www2.oregonscientific.com/about/international.
asp
EU-DECLARATION OF CONFORMITY
Hereby, Oregon Scientific, declares that this
Heart Rate Monitor with PC, Distance and
Speed (model SE833) is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC. A copy of
the signed and dated
Declaration of Conformity
is available on request via our Oregon Scientific
Customer Service.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device must
accept any interference received, including
interference that may ca
use undesired
operation.
WARNING Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTE This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against
harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
gu
arantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encoura
ged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio /
TV technician for help.
DECLARATION OF CONFORMITY
The following information is not to be used as
contact for support or sales.
Please visit our
website at www2.oregonscientific.com/service
for all enquiries.
We
Name: Oregon Scientific, Inc.
Address: 19861 SW 95
th
Ave.,Tualatin,
Oregon 97062 USA
Telephone No.: 1-800-853-8883
declare that the product
Product No.: SE833
Product Name: Heart Rate Monitor with PC,
Distance and Speed
Manufacturer: IDT Technology Limited
Address: Block C, 9/F, Kaiser
Estate,
Phase 1,41 Man Yue St.,
Hung Hom, Kowloon,
Hong Kong
is in conformity with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: 1) This device may not cause
harmful interference. 2) This
device must
accept any interference received, including
interference that may cause undesired
operation.