User's Manual

6
GB
HOW TO READ THE LOW BATTERY
INDICATOR
Replace the batteries when the low-battery indicator for the Ringer or bell
push appears.
HOW TO SET THE CHIME VOLUME
Press [ VOLUME ] on the main unit to select between high and low
volume. The volume level will be displayed.
HOW TO SET THE SYSTEM CODE
This product uses a coding system to avoid interference among neighbouring
Oregon Scientific wireless products. In the unlikely event that the unit
rings without anyone of your bell push being used, it means another Oregon
Scientific wireless product in the neighbourhood is using the same codes as
your own. You should then change the security system code. The code set
for the bell push and the Ringer must be identical before they can work
properly together.
main
ch.1
ch. 2
ch. 3
Low battery indicator
Main unit
Channel 1 bell push
Channel 2 bell push
Channel 3 bell push
To set the code for the Doorbell,
1. Press and hold [ CODE ] for two seconds.
2. Use [
] to enter the code. You can select from 1 to 16.
3. Press [ CODE ] to confirm and exit.
Once set, the Ringer will retain the system code even when the batteries are
removed.
To set the code for the bell push,
1. Open the battery compartment door of the bell push.
2. Set the code on the system code switch as shown below. There are 16
combinations.
3. Replace the battery compartment door.