User's Manual
EN
9
3. Relax your hand and press to turn on the unit.
4. Select user:
Press User Memory
Guest No memory stored
User 1 Memory stored under User 1
User 2 Memory stored under User 2
A voice will prompt you to sit in the correct position.
5. Press
again to begin measurement. A voice will
remind you to relax and remain still. Wrist cuff will begin
inating automatically to measure blood pressure.
TIP To stop the measurement process at any time, press
.
Once the pressure reaches a certain level, it will slowly
deate until the measurement results are displayed on the
LCD.
This unit can intelligently adjust the cuff pressure and inate
to a higher-pressure level (>180 mmHG) when needed.
Your systolic and diastolic pressure readings ash on the
LCD, followed by MAP and pulse per minute readings every
2 seconds. At the same time, your measurement results and
the blood pressure classication will also be announced.
NOTE The unit automatically attempts to send record
wirelessly to the hub. “PC” will appear on the screen. If data
transmission fails, “Err” will appear on the screen.
The unit switches off 1 minute after taking a measurement.
To save battery life, press
as soon as you are nished to
turn off the unit.
VOICE ANNOUNCEMENT
The BPW800 features voice playback during and after
blood pressure measurement results, as well as general
instructions to help you prepare for taking measurements.
When the unit has nished taking your measurement,
your blood pressure readings, pulse and blood pressure
classication are announced.
To repeat announcement: Press TALK / VOLUME.
To change volume:
1. Press and hold TALK / VOLUME
.
2. Press TALK / VOLUME repeatedly to select desired
volume.
Volume setting Volume level
0 Mute
1 Low
2 High
3. To exit, press
or SET.
BPW800_EN_R8.indd 9 2011/6/8 7:07:06 PM