Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy IR Receiver Module(SE027)

1．Introduction

This module usually used together with the IR transmit Module, it can read infrared

light value. It’ similar with the IR Receiver Module (ST1089), the difference is that this

module has one indicator light, which would be on when this module’s voltage signal

is changed. And, this module has integrated 3-pin terminal, which can be simply and

tidily connected with Arduino sensor expansion board, like the following picture:

Specification

 Operation voltage: 5V

 With 3-Pin Jumper

 Size:25*12mm

 Weight: 4g

2 Pinout

Description

DAT

Digital signal input pin, used to read the

value of infrared light.

VCC

Power

PAGE 1
IDUINO for Maker’s life Easy IR Receiver Module(SE027) 1．Introduction This module usually used together with the IR transmit Module, it can read infrared light value. It’ similar with the IR Receiver Module (ST1089), the difference is that this module has one indicator light, which would be on when this module’s voltage signal is changed.
PAGE 2
IDUINO for Maker’s life GND Ground 3.Example In this example, you need an Infrared transmit device, like mini remote controller, directly point the remoter to this module, which can read the hexadecimal value of the infrared light and print on the window. The connection as below: Example code : ******Code begin****** # Include int RECV_PIN = 11; // define input pin on Arduino IRrecv irrecv (RECV_PIN); decode_results results; void setup () { Serial.begin (9600); irrecv.
PAGE 3
IDUINO for Maker’s life } } ******Code End****** www.openplatform.