Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy Crash Switch sensor(SE032)

1 Introduction

This module called Crash switch sensor. When this module be crash, it will output low

or high signal for your control. Sometimes we call this limited switch, it’s widely used

in somewhere one object’s motion is stopped to certain location. This module has one

indicator light, which would be on when this module’s voltage signal is changed. And,

this module has integrated 3-pin terminal, which can be simply and tidily connected

with Arduino sensor expansion board, like the following picture:

Specification

 Operation voltage: 5V

 With 3-Pin Jumpers

 Size:25*15mm

 Weight:4g

2 Pinout

Description

OUT

If the sensor detect a crash, this pin

PAGE 1
IDUINO for Maker’s life Easy Crash Switch sensor(SE032) 1 Introduction This module called Crash switch sensor. When this module be crash, it will output low or high signal for your control. Sometimes we call this limited switch, it’s widely used in somewhere one object’s motion is stopped to certain location. This module has one indicator light, which would be on when this module’s voltage signal is changed.
PAGE 2
IDUINO for Maker’s life Vcc Gnd output low or high level signal Power Ground 3.Example In this example, you need connect a LED to pin13 to see when this module be rotated, what will happen.
PAGE 3
IDUINO for Maker’s life { digitalWrite (Led, HIGH); } else { digitalWrite (Led, LOW); } } ******Code End****** www.openplatform.