Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Vibration Shock module(SE053)

1 Introduction

This module is a shock switch module, and if it can detect a jolt ,it output one low

level signal. Be similar with our most sensor, It has three pin: Power pin, Ground pin

and signal switch pin. That’s an interesting function to your Arduino project.

Specification

 Operation voltage: 5V

 3Pin

 Size:25*15mm

 Weight: 2g

2 Pinout

Description

If the sensor detect a jolt, this pin

output low level signal

+(middle pin)

Power

Ground

3.Example

This example show you how to use this module, connection as below, and upload

the sketch, open the serial monitor session, see how it will go~

PAGE 1
IDUINO for Maker’s life Vibration Shock module(SE053) 1 Introduction This module is a shock switch module, and if it can detect a jolt ,it output one low level signal. Be similar with our most sensor, It has three pin: Power pin, Ground pin and signal switch pin. That’s an interesting function to your Arduino project.
PAGE 2
IDUINO for Maker’s life Example code : ******Code begin****** int shockPin = 10; // Use Pin 10 as our Input int shockVal = HIGH; // This is where we record our shock measurement boolean bAlarm = false; unsigned long lastShockTime; // Record the time that we measured a shock int shockAlarmTime = 250; // Number of milli seconds to keep the shock alarm high void setup () { Serial.
PAGE 3
IDUINO for Maker’s life bAlarm = true; } } else { if( (millis()-lastShockTime) > shockAlarmTime Serial.println("no alarm"); bAlarm = false; } } } ******Code End****** www.openplatform.