Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy Hat LED Module(SE058)

1 Introduction

This module is a white LED module, the shape of the led looks like a hat. The

brightness of the LED can be controlled by the input pin. This module has integrated

3-pin terminal, which can be simply and tidily connected with Arduino sensor

expansion board, like the following picture:

Specification

 Operation voltage: 5V

 With 3-Pin Jumpers

 Size:25*15mm

 Weight: 4g

PAGE 1
IDUINO for Maker’s life Easy Hat LED Module(SE058) 1 Introduction This module is a white LED module, the shape of the led looks like a hat. The brightness of the LED can be controlled by the input pin. This module has integrated 3-pin terminal, which can be simply and tidily connected with Arduino sensor expansion board, like the following picture: Specification     Operation voltage: 5V With 3-Pin Jumpers Size:25*15mm Weight: 4g www.openplatform.
PAGE 2
IDUINO for Maker’s life 2 Pinout Pin IN Description Input signal pin, you can input stable voltage or a PWM signal Power Ground Vcc Gnd 3.Example In this example, you can see the brightness of the LED is changing. ******Code Begin****** void setup () { pinMode(11,OUTPUT); } void loop() { for (int a=0; a<=255;a++) { analogWrite(11,a); delay(8); } www.openplatform.
PAGE 3
IDUINO for Maker’s life for (int a=255; a>=0;a--) { analogWrite(11,a); delay(8); } delay(800); } ******Code End****** www.openplatform.