Datasheet

ManualsBrandsIduino ManualsDevelopment ToolsSensor module

Table Of Contents

Description

Water Turbidity Test Sensor for Arduino

Description

The turbidity sensor detects water quality by measuring level of turbidity.

The principle is to convert the current signal itself into the voltage output through

the circuit.

Its detection range is 0%-3.5% (0-4550NTU) , with an error range of ±05%F*S.

When using, measure the voltage value of sensor’s Signal end; then work out the

water’s turbidity by simple calculation formula.

This turbidity sensor have both analog and digital signal output modes.

The module has a slide switch. When slide the switch to A end, connect the signal

Summary of content (7 pages)

PAGE 1
Water Turbidity Test Sensor for Arduino Description The turbidity sensor detects water quality by measuring level of turbidity. The principle is to convert the current signal itself into the voltage output through the circuit. Its detection range is 0%-3.5% (0-4550NTU) , with an error range of ±05%F*S. When using, measure the voltage value of sensor’s Signal end; then work out the water’s turbidity by simple calculation formula. This turbidity sensor have both analog and digital signal output modes.
PAGE 2
end to analog port, can read the analog value to calculate the output voltage so as to get the turbidity degree of water. If slide to D end, connect signal end to digital port, can detect the water whether is turbidity by outputting HIGH or LOW level. You can turn the blue potentiometer on the sensor to adjust the sensitivity of sensor.
PAGE 3
Specification  Operating Voltage: DC 5V  Operating Current: about 11mA  Detection Range: 0%--3.5%（0-4550NTU）  Operating Temperature: -30℃~80℃  Storage Temperature：-10℃~80℃  Error Range: ±0.
PAGE 4
Electrical Characteristic Curve The corresponding table of output voltage and concentration shows that the higher the turbidity value is, the lower the output voltage is. In the chart, many customers do not know how to convert the percent（%）to turbidity units (NTU). The following conversion formula is obtained after verification: 10-6 (PPM)=1ppm=1mg/L=0.13NTU (empirical formula) that is: 3.
PAGE 5
Special Notice: 1) The top of probe is not water-proof; can only place the transparent part into water. 2) Pay more attention to the power polarity when wiring. Avoid burning out the sensor due to reversed connection. The voltage can only be DC5V; pay close attention to the voltage to prevent overvoltage from burning the sensor.
PAGE 6
Serial.begin(9600);}// the loop routine runs over and over again forever:void loop() { // read the input on analog pin 0: analogRead(A0); // print out Serial.println(sensorValue); delay(100); the int sensorValue = value you read: // delay in between reads for stability} Test Result In the experiment, we slide the switch to A end, then read the analog value shown below. The analog value 0-1023 corresponds to voltage 0-5V.
PAGE 7