Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy Vibration Shock module(SE025)

1 Introduction

This module is a shock switch module, and if it can detect a jolt ,it output low level

signal. It’ similar with the Vibration Shock module (SE053), the difference is that this

module has one indicator light, which would be on when this module’s voltage signal

is changed. And, this module has integrated 3-pin terminal, which can be simply and

tidily connected with Arduino sensor expansion board, like the following picture:

Specification

 Operation voltage: 5V

 With 3-Pin Jumper

 Size:25*15mm

 Weight: 6g

2 Pinout

Description

OUT

If the sensor detect a jolt, this pin

output low level signal

VCC

Power

PAGE 1
IDUINO for Maker’s life Easy Vibration Shock module(SE025) 1 Introduction This module is a shock switch module, and if it can detect a jolt ,it output low level signal. It’ similar with the Vibration Shock module (SE053), the difference is that this module has one indicator light, which would be on when this module’s voltage signal is changed.
PAGE 2
IDUINO for Maker’s life GND Ground 3.
PAGE 3
IDUINO for Maker’s life { shockVal = digitalRead (shockPin) ; // read the value from our sensor if (shockVal == LOW) // If we're in an alarm state { lastShockTime = millis(); // record the time of the shock if (!bAlarm){ Serial.println("IDUINO Shock module"); bAlarm = true; } } else { if( (millis()-lastShockTime) > shockAlarmTime Serial.println("no alarm"); bAlarm = false; } } } ******Code End****** www.openplatform.