Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy IR Transmitter Module(SE028)

1．Introduction

This module usually used together with the IR Receiver Module, this module’s

application are very wide in our common life. It’ similar with the IR Transmitter Module

(ST1087), the difference is that this module has one indicator light, which would be on

when this module’s voltage signal is changed. And, this module has integrated 3-pin

terminal, which can be simply and tidily connected with Arduino sensor expansion

board, like the following picture:

Specification

 Operation voltage: 5V

 With 3-Pin Jumper

 Size:25*12mm

 Weight: 4g

2 Pinout

Description

DAT

Digital signal input pin, if this pin detect

a HIGH signal, this module transmit

PAGE 1
IDUINO for Maker’s life Easy IR Transmitter Module(SE028) 1．Introduction This module usually used together with the IR Receiver Module, this module’s application are very wide in our common life. It’ similar with the IR Transmitter Module (ST1087), the difference is that this module has one indicator light, which would be on when this module’s voltage signal is changed.
PAGE 2
IDUINO for Maker’s life Vcc Gnd infrared light Power Ground 3.example In this example, we use the basic sketch in the Arduino IDE, blinking this Infrared LED. You can’t see the light through your light by your eye, but you can catch the infrared light by an infrared receive device, like module 35, or just a camera. The connection as below: Example code : ******Code begin****** void setup() { // initialize digital pin 13 as an output.