User manual

IDUINO for Maker’s life

www.openplatform.cc

Easy Piranha LED Module-Red (SE038)

1．Introduction

Piranha LED light module, and special sensors Arduino board and ambient light

sensor extension combination, can be used in the interaction with the light works.

When the LED light module connected to Arduino, the digital pin (LOW on, HIGH off)

is used to control it. The brightness of LED can be controller via PWM output. It has

different color LEDs, default is red. And, this module has integrated 3-pin terminal,

which can be simply and tidily connected with Arduino sensor expansion board, like

the following picture:

PAGE 1
IDUINO for Maker’s life Easy Piranha LED Module-Red (SE038) 1．Introduction Piranha LED light module, and special sensors Arduino board and ambient light sensor extension combination, can be used in the interaction with the light works. When the LED light module connected to Arduino, the digital pin (LOW on, HIGH off) is used to control it. The brightness of LED can be controller via PWM output. It has different color LEDs, default is red.
PAGE 2
IDUINO for Maker’s life 2 Pinout Pin IN VCC GND Description Signal Input pin Power Ground 3.Example Wire connection as below: Vcc-----------5V Gnd-----------gnd IN-----------D11 ******Code begin****** void setup () { pinMode(11,OUTPUT); } void loop() { for (int a=0; a<=255;a++) { analogWrite(11,a); delay(8); } for (int a=255; a>=0;a--) { analogWrite(11,a); delay(8); } delay(800); } ******Code End****** www.openplatform.