Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Easy Button Switch Module(SE046)

1．Introduction

This module is simple and basic button switch module, usually used as the switch

of you diy project, when the button is pressed, the circuit is on, otherwise it off. And,

this module has integrated 3-pin terminal, which can be simply and tidily connected

with Arduino sensor expansion board, like the following picture:

PAGE 1
IDUINO for Maker’s life Easy Button Switch Module(SE046) 1．Introduction This module is simple and basic button switch module, usually used as the switch of you diy project, when the button is pressed, the circuit is on, otherwise it off. And, this module has integrated 3-pin terminal, which can be simply and tidily connected with Arduino sensor expansion board, like the following picture: www.openplatform.
PAGE 2
IDUINO for Maker’s life Specification  Operation voltage: 5V  With 3-pin Jumper 2 Pinout Pin OUT VCC GND Description Digital signal output pin Power Ground 3.Example Wire connection as below: Vcc-----------5V Gnd-----------gnd OUT-----------D3 ******Code begin****** int Led=13; int button=3; int val; void setup() { pinMode(Led,OUTPUT); pinMode(button,INPUT); } void loop() { val=digitalRead(button); if(val==HIGH) { digitalWrite(Led,LOW); } else { digitalWrite(Led,HIGH); } } ******Code End****** www.