User manual

IDUINO for maker’s life

www.openplatform.cc

Two Color LED Module 5mm (SE057)

1 Introduction

This module can gradually generate two kinds color, Red and Green, from the one

color to the other one. The “s” pin represents Red color and the middle pin means

Green color.

Specification:

 Color: Green + Red

 Diameter: 5mm

 Case Color: None

 Package Type: Diffusion

 Voltage (V): G :2.3-2 .6 V; R :1.9-2 .2 V

 Using a current (MA): 20

 Viewing angle: Wavelength (NM): 571 +625

 Luminous intensity (MCD) :20-40; 60-80

 Stent type: long-legged

PAGE 1
IDUINO for maker’s life Two Color LED Module 5mm (SE057) 1 Introduction This module can gradually generate two kinds color, Red and Green, from the one color to the other one. The “s” pin represents Red color and the middle pin means Green color. Specification:  Color: Green + Red  Diameter: 5mm  Case Color: None  Package Type: Diffusion  Voltage (V): G :2.3-2 .6 V; R :1.9-2 .
PAGE 2
IDUINO for maker’s life 2 pinout Pin S Middle pin - Description Red color pin Green color pin Ground 3. Example Here is a example show that the color of the LED gradually change to Green from Red. The connection as below: ********Code Begin******** int redpin = 11; // select the pin for the red LED int greenpin = 10;// select the pin for the greenLED int val; void setup () { pinMode (redpin, OUTPUT); pinMode (bluepin, OUTPUT); Serial.
PAGE 3
IDUINO for maker’s life analogWrite (10, 255-val); delay (15); } for (val = 0; val <255; val ++) { analogWrite (11, val); analogWrite (10, 255-val); delay (15); } Serial.println (val, DEC); } ********Code End******** www.openplatform.