Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Ball Switch sensor(SE059)

1 Introduction

This module called Ball switch sensor, just like a ball tilt switch, similar with the

mercury tilt switch. When this module be tilted, it will output low or high signal for

your control.

Specification

 Operation voltage: 5V

 3Pin

 Size:25*15mm

 Weight: 2g

2 Pinout

Description

If the sensor detect a tilt, this pin

output low or high level signal

+(middle pin)

Power

Ground

3.Example

In this example, you need connect a LED to pin13 to see when this module be

rotated, what will happen.

PAGE 1
IDUINO for Maker’s life Ball Switch sensor(SE059) 1 Introduction This module called Ball switch sensor, just like a ball tilt switch, similar with the mercury tilt switch. When this module be tilted, it will output low or high signal for your control. Specification     Operation voltage: 5V 3Pin Size:25*15mm Weight: 2g 2 Pinout Pin S +(middle pin) - Description If the sensor detect a tilt, this pin output low or high level signal Power Ground 3.
PAGE 2
IDUINO for Maker’s life ******Code Begin****** int Led = 13 ;// define LED Interface int buttonpin = 3; // define the tilt switch sensor interfaces int val ;// define numeric variables val void setup () { pinMode (Led, OUTPUT) ;// define LED as output interface pinMode (buttonpin, INPUT) ;//define the output interface tilt switch sensor } void loop () { val = digitalRead (buttonpin) ;// digital interface will be assigned a value of 3 to read val if (val == HIGH) //When the tilt sensor detects a signal when