User manual

• The appliance starts the countdown.
• When the countdown is completed,
the programme starts automatically.
You can cancel or change the
set of the delay start before you
press the button Départ/Pause.
To cancel the delay start:
1. Press the button Départ/Pause to set
the appliance to pause.
2. Press Départ Différé until the indicator
of the set delay goes off.
Press Départ/Pause again to start the
programme immediately.
Interrupting a programme and
changing the options
You can change only some options before
they operate.
1.
Press the button Départ/Pause . The
indicator flashes.
2.
Change the options.
3.
Press the button Départ/Pause again.
The programme continues.
Opening the lid
While a programme operates or the delay
start operates, the appliance lid is locked.
CAUTION! If the temperature
and level of the water in the
drum are too high, you cannot
open the lid.
Open the lid during the first 10 minutes
of the cycle and when the delay start
operates:
1. Press the button Départ/Pause to
pause the appliance.
2. Wait a couple of minutes and then you
can open a lid.
3. Close the lid and press button Départ/
Pause again. The programme
continues (or the delay start).
Open the lid when the programme
operates:
1. Turn the programme knob to position
Arrêt to deactivate the appliance.
2. Wait for some minutes and then open
the appliance lid.
3. Close the lid and set the programme
again.
Cancelling a running
programme
1. Turn the programme knob to position
Arrêt to cancel the programme and to
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance could
drain the water. in this case,
make sure that the detergent is
still in the detergent
compartment, if not fill the
detergent again.
At the end of the programme
• The appliance stops automatically.
• The indicator of the button Départ/
Pause goes off.
• The indicator Fin is on.
• You can open the lid.
• Remove the laundry from the appliance.
Make sure that the drum is empty. Close
the water tap.
• Turn the programme knob to position
Arrêt to deactivate the appliance.
• Keep the lid ajar, to prevent the mildew
and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator of button Départ/Pause
flashes. The lid stays locked.
• You must drain the water to open the lid.
To drain the water:
1. Set a "Drain" or a "Spin" programme. If
necessary, decrease the spin speed.
2. Press the button Départ/Pause. The
appliance drains the water and spins.
3. When the programme is completed,
after a couple of minutes, you can open
the lid.
4. Turn the programme knob to position
Arrêt to deactivate the appliance.
11