User manual

farm houses; staff kitchen areas in shops, offices and
other working environments;
by clients in hotels, motels, bed & breakfast and other
residential type environments.
Do not change the specification of this appliance.
Obey the maximum load volume of 5,5 kg (refer to the
“Programme chart” chapter).
The operating water pressure (minimum and maximum)
must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).
The ventilation openings in the base (if applicable) must not
be obstructed by a carpet.
The appliance is to be connected to the water mains using
the new supplied hose-sets. Old hose sets must not be
reused.
If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Before maintenance, deactivate the appliance and
disconnect the mains plug from the mains socket.
Do not use water spray and steam to clean the appliance.
Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
SAFETY INSTRUCTIONS
Installation
Remove all the packaging and the transit
bolts.
Keep the transit bolts. When you move
the appliance again you must block the
drum.
Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
Do not install or use a damaged
appliance.
Obey the installation instruction supplied
with the appliance.
Do not install or use the appliance where
the temperature is less than 0 °C or
where it is exposed to the weather.
Make sure that the floor where you
install the appliance is flat, stable, heat
resistant and clean.
Make sure that there is air circulation
between the appliance and the floor.
Adjust the feet to have the necessary
space between the appliance and the
carpet.
Do not install the appliance where the
appliance lid can not be fully opened.
Electrical connection
The appliance must be earthed.
Always use a correctly installed
shockproof socket.
3