EN User Manual Washing Machine PTL7100P
CONTENTS Safety information Safety instructions Product description Control panel Programme Chart Consumption values Options 2 3 5 5 6 8 9 Before first use Daily use Hints and tips Care and cleaning Technical Data Troubleshooting Installation 10 10 12 14 16 16 18 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions.
• • • • • • • • • Do not exceed the maximum load of 7 kg (refer to the "Programme chart" chapter). The operating water pressure at the water entry point from the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
Electrical connection • The appliance must be earthed. • Always use a correctly installed shockproof socket. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the mains plug and to the mains cable. Should the mains cable need to be replaced, this must be carried out by our Authorised Service Centre.
PRODUCT DESCRIPTION Appliance overview 1 1 2 3 4 5 2 3 5 Control panel Lid Lid handle Feet for levelling the appliance Rating plate 4 CONTROL PANEL Control panel description 1 2 3 DELAY START OFF MINI 30 JEANS REFRESH 20 MIN EASY IRON SPIN DRAIN TEMPERATURE COTTON 9H 900 700 QUICK PREWASH / WASH RINSE / SPIN 500 SYNTHETICS RINSE HOLD 40° DELICATE SPIN WOOL OPTION END EXTRA RINSE START / PAUSE 30° MIX 20° 8 Programme knob Temperature selection knob Delay start button Indicator
Indicators END - end of cycle The indicator comes on when the pro‐ gramme is completed. PREWASH/WASH - washing phase The indicator comes on after pressing the START/PAUSE button. This means the ap‐ pliance is operating. RINSE/SPIN - rinsing phase The indicator comes on when the appliance performs the extra rinse phase. PROGRAMME CHART Programme Temperature range Maxi‐ mum load Maxi‐ mum spin speed Programme description (Type of load and soil level) COTTON 90°C - Cold 7 kg 1000 rpm White cotton.
Programme Temperature range Maxi‐ mum load Maxi‐ mum spin speed Programme description (Type of load and soil level) SPIN 7 kg 1000 rpm To spin the laundry and to drain the water in the drum. All fabrics, except woollens and delicate fabrics. EASY IRON 60°C - Cold 1 kg 900 rpm Synthetic items requiring a gentle wash. Normal REFRESH 20 MIN 30°C 1 kg 900 rpm Synthetic and delicate items. Light soil items or items to refresh. JEANS 60°C - Cold 3 kg 1000 rpm Items in denim and jersey.
DELAY START EXTRA RINSE QUICK1) SPIN Programme RINSE HOLD 8 COTTON ECO ■ ■ ■ ■ ■ SYNTHETICS ■ ■ ■ ■ ■ ■ DELICATE ■ ■ ■ ■ ■ ■ WOOL ■ ■ ■ MIX 20° ■ ■ ■ ■ ■ RINSE ■ ■ ■ ■ ■ ■ DRAIN ■ SPIN ■ ■ EASY IRON ■ ■ REFRESH 20 MIN ■ ■ JEANS ■ ■ MINI 30 ■ ■ ■ ■ ■ ■ ■ ■ ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory.
Programmes Load (kg) Energy consump‐ tion (kWh) Water consump‐ tion (litre) Approxi‐ mate pro‐ gramme duration (minutes) Remain‐ ing mois‐ ture (%)1) COTTON 60°C 7 1,16 58 197 60 COTTON 40°C 7 0,61 56 192 60 SYNTHETICS 40°C 3 0,45 46 105 37 DELICATE 40°C 2,5 0,55 46 90 37 WOOL2) 30°C 1,5 0,35 50 65 32 7 0,95 47 255 60 3,5 0,65 39 188 60 3,5 0,59 39 187 60 Standard cotton programmes Standard 60°C cot‐ ton Standard 60°C cot‐ ton Standard 40°C cot‐ ton 1) A
• Set this option to deactivate all spin phases. Only the drain phase is available. • Set this option for very delicate fabrics. • The rinses phase uses more water for some washing programmes. • The door stays locked. You must drain the water to unlock the door. To drain the water refer to "Draining water out after the end of the cycle". EXTRA RINSE QUICK With this option you can decrease the programme duration. Use this option for items with light soil or items to refresh.
2. Put the detergent and the fabric conditioner into the proper compartments. Always obey the instructions that you find on the packaging of the detergent products. When you set a prewash option, put the deter‐ gent for prewash phase directly into the drum. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). The mark M is the maximum level for the quantity liquid additives. Setting a programme 1.
CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the lid. Open the lid during the first 10 minutes of the cycle and when the delay start operates: 1. Press the button START/PAUSE to pause the appliance. 2. Wait a couple of minutes and then you can open a lid. 3. Close the lid and press button START/ PAUSE again. The programme continues (or the delay start). Open the lid when the programme operates: 1.
• Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items. • Turn multilayered fabrics, wool and items with painted illustrations inside out. • Remove hard stains with a special detergent. • Wash and pre-treat heavy soil stains before putting items in drum • Be careful with the curtains.
CARE AND CLEANING WARNING! Refer to Safety chapters. External cleaning Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. Always obey the instructions that you find on the packaging of the product. Maintenance wash With the low temperature programmes it is possible that some detergent stays in the drum. Perform a maintenance wash regularly. To do this: Descaling • Remove all laundry from the drum.
1 2 3. 4. Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 90˚ Frost precautions If the appliance is installed in an area where the temperature can be less than 0°C, remove the remaining water from the inlet hose and the drain pump. Do this procedure also when you want to do the emergency drain. 1. Close the water tap. 2. Remove the water inlet hose.
3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4. Put the ends of each drain and inlet hose in a container. Let the water flow out of the hoses. 5. Set the Drain programme and let it operate until the end of the cycle. 6. Turn the programme knob to position OFF to deactivate the appliance. 7. Disconnect the appliance from the mains socket. WARNING! Make sure that the temperature is more than 0°C before you use the appliance again.
• - The mains supply is unstable. Wait until the mains supply is stable. • - The appliance drum doors are open or not closed correctly. Please close drum doors ! WARNING! Deactivate the appliance before you do the checks. Possible failures Problem Possible solution The programme does not start. • • • • • • The appliance does not fill with water properly. • • • • • The appliance does not drain the water.
Problem Possible solution There is water on the floor. • You cannot open the ap‐ pliance lid. • • Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the drum. The appliance makes an unusual noise. • Make sure the levelling of the appliance is correct. Refer to 'Installation'. Make sure that the packaging and/or the transit bolts are re‐ moved. Refer to 'Installation'. Add more laundry in the drum. The load may be too small.
Unpacking 1. 2. 1 2 2 1 2 3.
Positioning Water supply FI 3/4” SE 1/2” NO 3/4” DK 3/4” 2 1 90O Drainage min.600 mm max.1000 mm ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
* Hg Cd Cr6+ Hazardous substances PBBs PBDEs 1. This table is compiled according to SJ/T11364-2014. means this kind of hazard substance content in all the homogenous material of this part is under the limitation regulated 2. in GB/T26572-2011. 3. X means this kind of hazard substance content in at least one homogenous material of this part is above the limitation regulated in GB/T26572-2011. 4.
192935270-A-022018