User's Manual Part 2
Table Of Contents
- 2 Unpacking
- 3 Installation
- 3.1 Anti-static Precautions
- 3.2 Installation Precautions
- 3.3 Preinstalled Components
- 3.4 CF Card Installation
- 3.5 Mounting the System
- 3.6 Bottom Panel Connectors
- 3.6.1 External Peripheral Device Connection
- 3.6.2 ACC Mode Selection
- 3.6.3 AT/ATX Power Mode Selection
- 3.6.4 Audio Connectors
- 3.6.5 CAN-bus Terminal Block
- 3.6.6 LAN Connector
- 3.6.7 Power Input 1, 3-pin Terminal Block
- 3.6.8 Power Input 2, DIN Connector
- 3.6.9 RJ-45 RS-232 Serial Port
- 3.6.10 RS-422/485 Serial Port
- 3.6.11 USB Connectors
- 3.6.12 VGA Connector
- 3.7 Redundant Power
- 3.8 Remote Control
UPC-V312-D525 Panel PC
Page 22
3.4 CF Card Installation
The UPC-V312-D525 has one CF Type II slot. To install the CF card, follow the
instructions below.
Step 1: Locate the CF card socket. The CF card socket is located on the left side panel
of the UPC-V312-D525.
Step 2: Remove the CF card slot panel by removing the four retention screws.
NOTE:
Please use the screw driver that comes with the UPC-V312-D525 to
remove the screws on the chassis.
Figure 3-1: Remove the CF Card Slot Panel
Step 3: Install the CF Card. Correctly align the CF card with the socket and insert the
CF card into the socket. See
55Figure 3-2.
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m