User's Manual Part 2
Table Of Contents
- 2 Unpacking
- 3 Installation
- 3.1 Anti-static Precautions
- 3.2 Installation Precautions
- 3.3 Preinstalled Components
- 3.4 CF Card Installation
- 3.5 Mounting the System
- 3.6 Bottom Panel Connectors
- 3.6.1 External Peripheral Device Connection
- 3.6.2 ACC Mode Selection
- 3.6.3 AT/ATX Power Mode Selection
- 3.6.4 Audio Connectors
- 3.6.5 CAN-bus Terminal Block
- 3.6.6 LAN Connector
- 3.6.7 Power Input 1, 3-pin Terminal Block
- 3.6.8 Power Input 2, DIN Connector
- 3.6.9 RJ-45 RS-232 Serial Port
- 3.6.10 RS-422/485 Serial Port
- 3.6.11 USB Connectors
- 3.6.12 VGA Connector
- 3.7 Redundant Power
- 3.8 Remote Control
UPC-V312-D525 Panel PC
Page 25
The following installation options are available:
Arm mounting
Stand mounting
Wall mounting
The mounting methods are described below.
3.5.1 Arm Mounting
The UPC-V312-D525 can be installed on any arm that supports the standard VESA
mounting interface. An example arm is shown below.
Figure 3-5: VESA Compliant Arm
To install the UPC-V312-D525 on the arm, follow the directions below.
NOTE:
Make sure the arm supports standard VESA mounting. The
UPC-V312-D525 uses a VESA mounting to attach to the arm.
Step 1: The arm is purchased separately. Follow the instructions in the arm's user
manual to securely attach the arm to the wall.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the panel PC
onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
panel PC. The arm mount retention screw holes are shown in
Figure 3-3.
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m