User's Manual Part 2
Table Of Contents
- 2 Unpacking
- 3 Installation
- 3.1 Anti-static Precautions
- 3.2 Installation Precautions
- 3.3 Preinstalled Components
- 3.4 CF Card Installation
- 3.5 Mounting the System
- 3.6 Bottom Panel Connectors
- 3.6.1 External Peripheral Device Connection
- 3.6.2 ACC Mode Selection
- 3.6.3 AT/ATX Power Mode Selection
- 3.6.4 Audio Connectors
- 3.6.5 CAN-bus Terminal Block
- 3.6.6 LAN Connector
- 3.6.7 Power Input 1, 3-pin Terminal Block
- 3.6.8 Power Input 2, DIN Connector
- 3.6.9 RJ-45 RS-232 Serial Port
- 3.6.10 RS-422/485 Serial Port
- 3.6.11 USB Connectors
- 3.6.12 VGA Connector
- 3.7 Redundant Power
- 3.8 Remote Control
UPC-V312-D525 Panel PC
Page 16
2.1 Unpacking
To unpack the panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the panel PC has been properly
installed. This ensures the screen is protected during the installation
process.
Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2: Open the external (second) box.
Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4: Lift the monitor out of the boxes.
Step 5: Remove both polystyrene ends, one from each side.
Step 6: Pull the plastic cover off the panel PC.
Step 7: Make sure all the components listed in the packing list are present. Step 0:
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m
Click to buy NOW!
P
D
F
-
X
C
h
a
n
g
e
V
i
e
w
e
r
w
w
w
.
d
o
c
u
-
t
r
a
c
k
.
c
o
m