User's Manual

Page 23
Power up the system
To power-up the system, push the power button on the right side panel for three seconds until the
power status LED on the front panel lights up in green.
The following table lists the power LED status description.
DS-101 Status: Power On or Sleep
Power LED Status
Green Power on
Solid amber The battery is fully charged
Slowly flash in amber The battery is being charged
LED off Power cable disconnected
DS-101 Status: Power Off
Battery Power Status
Lower than 5% The power LED flash rapidly in amber after long-pressing the power button. The
battery power is too low to power up the DS-101.
5% ~ 10% The power LED light up in green after long pressing the power button. The
DS-101 can be powered on to access the software application.
Higher than 10% The power LED light up in green after long pressing the power button. The
DS-101 can be powered on to access the software application. When the power
is lower than 10%, the DS-101 will shut down automatically.
Replacing the battery
This section describes how to replace the battery if necessary.
1. Remove the two retention screws that secure the battery access panel. Then, lift the panel to
remove it.