Manual

EBC-3000 IEI Technology Corp. Page 7
Figure 14: Power Supply Bracket Retention Screws
Step 5: Replace the power supply.
Step 6: Secure the power supply bracket to the power
supply and then secure the power supply bracket to
the chassis as shown in
Figure 14.
Step 7: Secure the power supply to the front panel of the
chassis with the three screws as indicated in
Figure
13.
Step 8: Connect the power supply to the SBC according to
the SBC user manual.
SYSTEM FAN REPLACEMENT
To replace the system fan please follow the steps below.
NOTE:
Please ensure that the power of the computer is switched off before
fan replacement procedure.
Step 1: Remove the chassis cover.
Step 2: Disconnect the system fan cable from the SBC.
Step 3: Remove the system fan from the chassis by
removing the four retention screws on the back
panel (
Figure 15).
Figure 15: System Fan Retention Screws
Step 4: Install the new system fan with the four previously
removed retention screws.
Step 5: Reconnect the system fan cable connector.