Manual
Table Of Contents
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Connectors
- 4.1 Peripheral Interface Connectors
- 4.2 Internal Peripheral Connectors
- 4.2.1 BIOS Battery Connector
- 4.2.2 CompactFlash® Socket
- 4.2.3 Digital I/O Connector
- 4.2.4 Fan Connector
- 4.2.5 Front Panel Connector
- 4.2.6 IDE Connector
- 4.2.7 Infrared Interface Connector
- 4.2.8 Keyboard/Mouse Connector
- 4.2.9 LCD Backlight Inverter Connector
- 4.2.10 LED Connector
- 4.2.11 LVDS LCD Connector
- 4.2.12 MCU LAN Connector
- 4.2.13 PCIe Mini Card Slot
- 4.2.14 Power Connectors
- 4.2.15 SATA Drive Connectors
- 4.2.16 SATA Power Connectors
- 4.2.17 Serial Port Connectors (RS-232)
- 4.2.18 Serial Port Connectors (RS-422/485)
- 4.2.19 SO-DIMM Socket
- 4.2.20 SPDIF Connector
- 4.2.21 TV Out Connector
- 4.2.22 USB Connectors
- 4.3 External Peripheral Interface Connector Panel
- 5 Installation
- 6 BIOS Setup
- 7 Software Installation
- 8 Battery Monitoring
- A BIOS Options
- B Terminology
- C Digital I/O Interface
- D Watchdog Timer
- E Address Mapping
- F Hazardous Materials Disclosure
eKINO-945GSE Motherboard
Page 4
1 x Infrared connector
1 x Keyboard/mouse connector
1 x LCD backlight inverter connector
1 x LVDS connector
1 x PCIe Mini slot
2 x SATA drive connectors
2 x SATA power connectors
2 x Serial port connectors (RS-232)
1 x Serial port connector (RS-422/485)
1 x SO-DIMM socket
1 x TV output connector
1 x USB pin header (2 ports)
The eKINO-945GSE has the following external peripheral interface connectors on the
board rear panel.
1 x Audio stereo output
1 x Audio microphone input
1 x DVI
2 x LAN
2 x RS-232 serial ports
4 x USB 2.0
1 x VGA
The eKINO-945GSE has the following on-board jumpers:
AT/ATX selection
Clear CMOS
CompactFlash® card setup
COM3 RS-232/422/485 selection
LCD panel type selector
LCD voltage selector
UPS enable/disable
UPS/Battery mode selection (eKINO-945GSE-N270UPS only)