User guide

EP-308A/EP-308AS POS
Page 14
Step 2: Insert the RJ-45 to DB-9 cable.
Step 3: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the cable. See
Figure 2-6.
Figure 2-6: Serial Device Connector
Step 4: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
2.5.3 USB Device Cable
To connect USB devices, please follow the instructions below.
Step 1: Located the USB connectors. The locations of the USB connectors are shown
in Chapter 2.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the bottom panel. See
Figure 2-7.