Owner manual
Table Of Contents
- 1 Introduction
- 2 Packing List
- 3 Connectors
- 4 Installation
- 5 BIOS
- 5.1 Introduction
- 5.2 Main
- 5.3 Advanced
- 5.4 Chipset
- 5.5 Boot
- 5.6 Security
- 5.7 Save & Exit
- 6 Software Drivers
- A BIOS Options
- B One Key Recovery
- C Terminology
- D Watchdog Timer
- E Hazardous Materials Disclosure
ICE-CV-D25501/N26001 COM Express Module
Page 31
Step 3: Place the heatspreader plate with the heat sink on the ICE-CV-D25501/N26001,
aligning the four retention screw holes (
Figure 4-4).
Step 4: Secure the heatspreader plate with the heat sink onto the baseboard with four
retention screws (
Figure 4-4).
Figure 4-4: Secure the Heatspreader Plate with the Heat Sink to the Baseboard
4.5 Installing USB 3.0 Driver during Windows® 7 OS Installation
If installing the Windows® 7 OS by using the USB 3.0 ports, loading the USB 3.0 driver
during the OS installation is necessary. Follow the instructions below to complete the task.
Step 1: Insert the USB flash drive containing the USB 3.0 driver into one of the USB 2.0
ports on the baseboard.
Step 2: After clicking the Install now button during the OS installation (
Figure 4-5), the
Load Driver screen appears (
Figure 4-6). Click Browse.