Instruction Manual

ICE-PV-N4551_D5251 COM Express Type 2 Module
Page 53
5.3.7 Super IO Configuration
Use the Super IO Configuration menu (3BIOS Menu 9) contains the submenus for
changing the FDD controllers, parallel ports and serial ports.
Aptio Setup Utility – Copyright (C) 2011 American Megatrends, Inc.
Advanced
Super IO Configuration
Super IO Chip Winbond W83627EHG
> Floppy Disk Controller Configuration
> COM 1 Configuration
> COM 2 Configuration
> Parallel Port Configuration
S
et Parameters of Floppy
Disk Controller (FDC)
---------------------
 : Select Screen
 : Select Item
Enter Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
BIOS Menu 9: Chipset
5.3.7.1 Floppy Disk Controller Configuration
 Floppy Disk Controller [Enabled]
Use the Floppy Disk Controller option to enable or disable the floppy disk drive.

Disabled
Disables the floppy disk controller.

Enabled DEFAULT
Enables the floppy disk controller.
 Change Settings [Auto]
Use the Change Settings option to set the serial port IO and interrupt addresses.

Auto DEFAULT
Disables the floppy disk controller.

IO=3F0h;
IRQ=6;
DMA=2
Serial Port I/O port address is 3F0h, the interrupt
address is IRQ6, and the DMA is 2.