Manual

ICE-QM770 COM Express Module
Page 33
4.5 Jumper Settings
4.5.1 LVDS Panel Type Selection
Jumper Label: SW1
Jumper Type:
DIP switch
Jumper Settings:
See
Table 4-1
Jumper Location:
See
Figure 4-4
This switch sets the resolution of the panel attached to the LVDS output.
The pin order listed in the first column of
Table 4-1 is: 4  3  2  1. (ON=0, OFF=1)
SW1 EDID Resolution Color Depth Channel
1111 640X480 18-bit Single
1110 800X480 18-bit Single
1101 800X600 18-bit Single
1100 1024X768 18-bit Single
1011 1024X768 24-bit Single
1010 1280X1024 24-bit Dual
1001 1600X1200 24-bit Dual
1000 1280X768 18-bit Single
0111 1280X800 18-bit Single
0110 1366X768 24-bit Single
0101 1440X900 24-bit Dual
0100 1600X900 24-bit Dual
0011 1680X1050 24-bit Dual
0010 1920X1080 24-bit Dual
0001 1920X1200 24-bit Dual
0000 LVDS disable
Table 4-1: LVDS Panel Type Selection