User's Manual

IKARPC-07A-A9 In-vehicle Panel PC
Page 16
 Anti-static Discharge: If a user open the rear panel of the flat panel PC, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear an anti-static wristband.
3.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the system
Step 2: Install a SD card
Step 3: Install a SIM card
Step 4: Mount the system
Step 5: Connect peripheral devices
Step 6: Power up the system Step 0:
3.4 SD Card Installation
To install the SD card, follow the instructions below.
Step 1: Remove the retention screw and lift the SD card slot access panel.
Figure 3-1: SD Card Slot Access Panel Retention Screw