User's Manual

IKARPC-07A-A9 In-vehicle Panel PC
Page 26
4.1 Power-On/Off Procedure
4.1.1 Installation Checklist
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power on the system please make sure of the following:
 The rear cover is installed
 All peripheral devices (antenna, serial communications devices etc.) are
connected
 The system is securely mounted
 The power cables are plugged in
4.1.2 Power-on Procedure
To power-on the IKARPC-07A-A9 please follow the steps below:
Step 1: Connect the ACC power cable from the IKARPC-07A-A9 to the power source.
See Section 3.7.4.