Owner's manual

IMB-Q354 microATX Motherboard
Page 76
4.7.3 USB Cable (Dual Port)
The IMB-Q354 is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the IMB-Q354 USB connector.
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the IMB-Q354, connect the cable connectors to the
onboard connectors. See
Figure 4-15.
Figure 4-15: Dual USB Cable Connection