Instruction Manual

IMBA-9454 Motherboard
Page 91
Figure 5-9: Jumper Locations
5.4.1 CF Master/Slave Selection
Jumper Label:
JP2
Jumper Type:
2-pin header
Jumper Settings:
See Table 5-2
Jumper Location:
See Figure 5-9
The CF Master/Slave Selection jumper sets the CF Type I card or CF Type II cards as
either the slave device or the master device. CF Master/Slave Selection jumper settings
are shown in Table 5-2.
Pins Description
Open Slave Default
Short Master
Table 5-2: CF Master/Slave Selection Settings