User guide

2011/8/172011/8/17
IMBA-G410 ATX Motherboard
Page 61
Figure 4-20: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector.
4.6.5 Serial Device Connection
The IMBA-G410 has one male DB-9 connectors on the external peripheral interface panel
for a serial device. Follow the steps below to connect a serial device to the IMBA-G410.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
66Figure 4-21.